Sample Conditioning

Sample Probe with Heater

To ensure samples have a faster response it is best practice to mount the sample regulator as close as possible to sample point. LXA systems achieves this as the regulator is mounted directly on the sample probe. The sample probe has an integral membrane which rejects free liquids. These are turned to the pipeline through a drain. 

EnPro LXA Sample Probe Handling System

The EnPro LXA is a sample probe conditioning system specially designed for analysers.

As the sample take off point is located in the flowing stream of gas there is differential between the inlet and return leg located at the outer edge of the pipe. Due to pressure differential caused a fresh representative sample is always available to the regulator.  

This hot loop design will also return liquids to the pipeline when rejected by the membrane at up to 200cc per minute based on 1.3 kPa differential pressure.



“I have been dealing with Haldatec for the past 15 years. In that time, they have consistently delivered beyond my expectations. From technical innovations to personalised site support, I can thoroughly recommend Haldatec for your pressure control / instrumentation requirements.” 

TW – Melbourne

“Very impressed with their attention to detail and commitment to designing a system which caters not only for our immediate needs, but also looking forward to our future needs. Their holistic approach has given us the confidence that they will always recommend the most appropriate choice and that they really look after their customers.”

CR - Sydney

“Great end to end service from Haldatec. They really took the time to understand our needs, then design and manufacture a solution for us. They have also provided ongoing support and advice whenever we’ve needed it since 1998.”

DP – Sydney

Contact Us

  • Phone+61 3 9872 5822
  • Fax+61 3 9872 5129
  • PostPO Box 3067, Nunawading VIC 3131
  • VisitUnit 11, 27-33 Thornton Crescent,
    Mitcham VIC 3132 View map

Send an Enquiry